How to fill a vacancy on a standing committee when a member resigns
Asked August 2026 · Answered by the AI Parliamentarian
When a standing committee member resigns, how is the replacement handled?
Filling Vacancies on Standing Committees
The General Rule
How a vacancy is filled depends on how the original appointment was made. Robert's Rules follows the principle that vacancies should be filled by the same authority that made the original appointment.
Common Scenarios
1. Committee Members Appointed by the Chair
If the chair originally appointed the member, the chair fills the vacancy by appointing a replacement, unless the bylaws or rules specify otherwise.
2. Committee Members Elected by the Assembly
If the assembly elected the member, the assembly elects a replacement through the normal election process.
3. Members Appointed by Another Method
If the bylaws specify a different appointment method (e.g., board appointment, executive committee), that same body fills the vacancy.
The Resignation Process
Before filling the vacancy, the resignation must be properly handled:
- Resignation is submitted to the appropriate officer or body
- Acceptance is required — a resignation is not effective until accepted
- The accepting authority is typically the one that made the original appointment
- Once accepted, the vacancy exists and can be filled
Important Caveats
- Check your bylaws first — they often specify vacancy procedures explicitly
- Standing rules or special rules may also address this
- If bylaws are silent, Robert's Rules' default rules apply
- The committee chair does not have authority to fill vacancies unless specifically authorized
Practical Tip
If your bylaws are silent on vacancies, it is good practice to have the assembly or board formally authorize whoever will fill the vacancy, to avoid procedural disputes later.